Name of the Organization : Reva University (reva.edu.in)
Type of Facility : PhD Entrance Examination Model Question Paper 2014
Location : Bangalore
Website : http://reva.edu.in/
PhD Entrance Examination Model Question Paper-2014 :
Electronics And Communication Engineering :
Duration- 2.00 Hours
Total Marks = 100
Note :
1) The question paper is in TWO parts, viz : Part-I and Part-II;
2) Part-I consists 50 questions of objective type carrying 1 mark each (50 x 1 = 50 marks)
3) Part-II consists of 25 questions of objective type carrying 2 marks each (25 x 2 = 50 marks)
4) All questions are compulsory.
Part-I :(50x 1 = 50)
Question-1 : 8051 can handle _______ interrupt sources.
A) 3 B) 4 C) 5 D) 6
Question-2 : By operating system, the resource management can be done via
A) Time division multiplexing
B) Space division multiplexing
C) Both (a) and (b)
D) None of the above
Part-II : (25 x 2 = 50)
Question-1 : What will be the contents of register AL after the following has been executed
MOV BL, 8C
MOV AL, 7E
ADD AL, BL
A) 0A and carry flag is set
B) 0A and carry flag is reset
C) 6A and carry flag is set
D) 6A and carry flag is reset
Question-2 : A digital communication system uses 8-PSK modulation and transmits 3600 bps. What is-
the symbol rate-
A) 10800 symbols/sec
B) 450 symbols/sec
C) 28800 symbols/sec
D) 1200 symbols/sec
Download Here :https://www.indianjobtalks.in/uploads/30496-RU-Phd-MQP-ECE.pdf
Civil Engineering:
Duration- 2.00 hours.
Total Marks = 100
Note :
1) The question paper is in TWO parts, viz : Part-I and Part-II.
2) Part-I consists 50 questions of objective type carrying 1 mark each (50 x 1 = 50 marks)
3) Part-II consists of 25 questions of objective type carrying 2 marks each (25 x 2 = 50 marks)
4) All questions are compulsory.
Part-I :(50 X 1 = 50)
Question-1 : The principle of superposition is valid only if the material is
(a) Elastic
(b) Stress-strain relationship is linear
(c) Plastic
(d) elasto-plastic.
Question-2 : Masonry arches resist the external loads by
(a) Bending moment and radial shear
(b) Thrust only
(c)Normal thrust, radial shear and moment
(d) Normal thrust and shear
Part-II :(25 x 2 = 50)
Question-1 :A moment M is applied to the free end of a cantilever beam. The slope at the free end is
(a) ML/4EI
(b) ML/3EI
(c) ML/2EI
(d) ML/EI
Question-2 : A three-hinged parabolic arch rib of span ‘L’ and crown rise ‘h’ carries a UDL of intensity “w’ per unit length over the entire span. The hinged supports are at the same level and the third hinge is located at left quarter span section. The horizontal thrust at the supports is
(a) wL2/4h
(b) wL2/6h
(c) wL2/8h
(d) wL2/12h
Download Here : https://www.indianjobtalks.in/uploads/30496-RU-Phd-MQP-CE.pdf